1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

O/T Moisture in headlight housing.

Discussion in 'Uncategorized Threads' started by ec90t, Jul 7, 2008.

Thread Status:
Not open for further replies.
  1. ec90t

    ec90t Guest

    Jackie,

    Check the housing for cracks. If one is found use a little epoxy to seal up the hole. If the crack is on the lense, you'll need to use one that hardens clear. Buff the lens once it has dried.

    The other thing is to check the gasket/oring where the bulb goes through the housing. Sometimes these will get boogered up and cause the same problem.

    ec90t
     
  2. ExFedex

    ExFedex Active Member

    Joined:
    Jan 29, 1998
    Messages:
    903
    We had an early Subaru once that did that and the replacements were very expensive. The guy at the junk yard told me to put those moisture absorbing pellets for humidity control inside after letting the lense or housing sit near a hot air vent over night. It worked.
     
  3. Bruce Specht

    Bruce Specht Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    5,057
    Location:
    Near but not in chicago
    Drill the hole in the bottom and be done with it, sometimes the old way is still the best
     
Thread Status:
Not open for further replies.