1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

NEED taller comb posts.

Discussion in 'Shooting Related Threads' started by pheasantsgalore, Jul 5, 2011.

Thread Status:
Not open for further replies.
  1. pheasantsgalore

    pheasantsgalore Active Member

    Joined:
    Mar 10, 2007
    Messages:
    1,181
    Location:
    Kansas City area
    Can someone recommend a machinist that can make me 2 sets of taller comb posts for adj comb hardware. Please e-mail at above, thanks again. I have the measurements off short sets, just need taller ones...Thanks....Rob
     
  2. skeet_man

    skeet_man Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    10,527
    Location:
    Rochester, NY
    You can make your own. Go to mcmaster.com and search for standoffs. Find the one the height and diameter you need. Then find some screws the right thread and 1/8" to 1/4" longer than the standoff, and your good to go.
     
  3. OldFalGuy

    OldFalGuy TS Member

    Joined:
    May 5, 2011
    Messages:
    8
    Guys-
    I have a friend with the opposite problem I believe as he
    is shooting a bit high but his comb is all the way down-
    Is the corrective action to lower the comb? Right?
    so the bottom of it will have t be shaved/reduced somehow??
     
  4. skeet_man

    skeet_man Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    10,527
    Location:
    Rochester, NY
    Bottom of the comb can be shaved, or a "canoe" of wood can be removed from the stock portion of the cut comb.
     
  5. Barry C. Roach

    Barry C. Roach Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    9,209
    Location:
    Scottsdale, AZ
    Tom Larkin (Minnesota stock man) has a selection of them. There are a few different sizes so you'll need to be very specific.
     
  6. pheasantsgalore

    pheasantsgalore Active Member

    Joined:
    Mar 10, 2007
    Messages:
    1,181
    Location:
    Kansas City area
    Thanks for input, and solutions..........Rob
     
  7. Landshark

    Landshark Member

    Joined:
    Jan 18, 2008
    Messages:
    445
    Tron made me a pair. They are top quality just like everything else he makes.
     
  8. trapwife

    trapwife Well-Known Member Supporting Vendor

    Joined:
    Jan 29, 1998
    Messages:
    2,601
    Have you tried to adjust your butt plate so the gun is "higher" and closer to your face?
     
  9. W.P.T.

    W.P.T. TS Member

    Joined:
    Jan 29, 1998
    Messages:
    8,371
    Tom Larkin, the Country Gentleman, or most any good gunny can do it for you ... Make sure you don't get them too tall or you won't be able to get the comb down where you need it ... They can make them shorter so they fit as they should also ... WPT ... (YAC) ...
     
Thread Status:
Not open for further replies.