1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Need help with Outers Trap Problem

Discussion in 'Shooting Related Threads' started by tom berry, Oct 13, 2009.

Thread Status:
Not open for further replies.
  1. tom berry

    tom berry Active Member

    Joined:
    Jan 29, 1998
    Messages:
    760
    Location:
    Winterset, IA
    Our little club has an Outers trap. I don't know which model. Last night it stop oscillating as it should. It basically makes about 1/2 - 3/4 complete cycle throughout a round of 25. It would throw 10 - 15 targets in the same place then move a few degrees.

    Anyone with any experience with these machines have any ideas?

    Thanks,

    Tom
     
  2. deercreek

    deercreek Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    1,131
    Location:
    Indiana
    Contact Jim Printz at Rhodeside in Piqua, OH. I am sure he could help you.
     
  3. scratcher

    scratcher TS Member

    Joined:
    Dec 23, 2005
    Messages:
    295
    Tom:

    Sounds like a circuit board problem. Contact either Jim Printz or Roger Wendling @ Monsoor's in LaCrosse, WI (608-784-0482).

    Dick Gries
     
  4. Joe Woods

    Joe Woods Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    1,496
    Tom: You are getting good advise, Dick will not steer you wrong.
    There is a gentleman in michigan who uses this equipment.
    Is it Del Nye's Shooting range. I am not to smart this am.

    Joe Woods/Ontario
     
  5. tom berry

    tom berry Active Member

    Joined:
    Jan 29, 1998
    Messages:
    760
    Location:
    Winterset, IA
    Thanks Dick. Good to hear from you again.

    Tom
     
Thread Status:
Not open for further replies.