1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Need a machinist for a short run NC job

Discussion in 'Uncategorized Threads' started by quicky, Oct 17, 2008.

Thread Status:
Not open for further replies.
  1. quicky

    quicky Member

    Joined:
    Jan 29, 1998
    Messages:
    255
    I need a quote for a short (50 items) NC lathe run. No hurry, can be used as a shop fill-in job. I would need them by the end of Feb., 2009. I can send photos of the job and an e-mailed dwg. I don't have anything digitized, but the part is pretty simple. Mat'l. is hot rolled or cold finished 1045 or 1050. I would take care of the angle, bevel and heat treating here on my end, so don't bid that part. Drop the X's from my e-mail address and I will check it as soon as possible. Thanks, Quicky xxxrotoscale@wyoming.comxxx
     
  2. KENENT1

    KENENT1 Active Member

    Joined:
    Jan 29, 1998
    Messages:
    1,393
    Location:
    Beloit, WI
    I sent you an email.


    tony
     
  3. quicky

    quicky Member

    Joined:
    Jan 29, 1998
    Messages:
    255
    Got it Tony, photos and dwg. should be there by now
     
  4. quicky

    quicky Member

    Joined:
    Jan 29, 1998
    Messages:
    255
Thread Status:
Not open for further replies.