1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Need a Gunsmith or advise on Beretta Auto

Discussion in 'Uncategorized Threads' started by mette56, Sep 15, 2008.

Thread Status:
Not open for further replies.
  1. mette56

    mette56 Well-Known Member

    Joined:
    Jul 8, 2008
    Messages:
    2,024
    Location:
    Camdenton, MO
    Need someone to install "piano wire" type hull catcher or advise on how to use clip-on type and not ruin the anodizing on the receiver.

    Thanks,

    milt
     
  2. cubancigar2000

    cubancigar2000 Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    10,521
    Location:
    Idaho
    I used a piece of thin masking tape under mine
     
  3. shannon391

    shannon391 Active Member

    Joined:
    Jan 29, 1998
    Messages:
    4,477
    Angleport or cole, clip on will not harm you reciever.
     
  4. Chester White

    Chester White Member

    Joined:
    Apr 24, 2006
    Messages:
    66
    Masking tape works for me also.
     
  5. spitter

    spitter Well-Known Member TS Supporters

    Joined:
    Jan 29, 1998
    Messages:
    4,348
    Location:
    Prairie State
    As a back up plan consider the portable elastic retention device (the good ol' rubber band).
     
  6. mette56

    mette56 Well-Known Member

    Joined:
    Jul 8, 2008
    Messages:
    2,024
    Location:
    Camdenton, MO
    Thanks to all for GREAT ADVISE!!!

    I've been using the masking tape idea for as long as the snap on's have been around, but found eventually it did wear the anodizing because the extra build-up would cause the catcher to pop-off occasionally. It did help but not eliminate the wear, for me anyway.

    Thanks again!

    milt
     
Thread Status:
Not open for further replies.