1. We have added the ability for anyone to 'bump' threads that they have created. This is mainly useful in the classifieds area where posters constantly bump for sale threads to bring it to the top. This allows them the ability to do that without having to clutter the thread with extra 'TTT' and 'Bump' type posts. To bump it, go inside your thread and click on 'Thread Tools' at the top, then select 'bump'. You can bump only once per 24 hour period.

    For more detailed information please see this post: Thread Bump Functionality.
    Dismiss Notice
  2. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Need 391 bent lifter

Discussion in 'For Sale- Members only' started by M R Ducks, Jul 13, 2011.

Thread Status:
Not open for further replies.
  1. M R Ducks

    M R Ducks Member

    0   0   0

    Joined:
    Jul 13, 2007
    Messages:
    667
    Location:
    Kabul, Afghanistan
    After a million rounds give or take - I need to replace the factory lifter on my 391 as my target loads occasionally hang up going into the chamber.

    Anyone have a bent one?

    Ducks
     
  2. TBFA

    TBFA Member

    Rating - 100%
    5   0   0

    Joined:
    Oct 13, 2010
    Messages:
    362
    You just need to replace your lifter with a 390 type lifter. Midwest gun works, or Cole's can hook you up
     
  3. TBFA

    TBFA Member

    Rating - 100%
    5   0   0

    Joined:
    Oct 13, 2010
    Messages:
    362
    You just need to replace your lifter with a 390 type lifter. Midwest gun works, or Cole's can hook you up
     
  4. M R Ducks

    M R Ducks Member

    0   0   0

    Joined:
    Jul 13, 2007
    Messages:
    667
    Location:
    Kabul, Afghanistan
    That's what I needed to know - thanks!

    Ducks
     
  5. GunDr

    GunDr Well-Known Member

    0   0   0

    Joined:
    Jan 29, 1998
    Messages:
    2,913
    If you have a plastic trigger housing, be sure that there are no missing pieces around the carrier's pivot pin.

    I have a 391 that the kids use on our youth league and it was not feeding properly, and I found a piece of plastic was broke off the RH side, causing the carrier to move left and right.

    Doug
     
  6. Dickgshot

    Dickgshot Well-Known Member

    0   0   0

    Joined:
    Jan 29, 1998
    Messages:
    3,675
    When you get the 390 carrier, you will need to have the lever and springs
    installed - which will add to the cost. You could remove the lever and springs from your current carrier and use them, but it's a very difficult job to do yourself and I don't recommend it.
     
Thread Status:
Not open for further replies.