1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

MIA's Sticky 391 problem

Discussion in 'Uncategorized Threads' started by ec90t, Feb 3, 2008.

Thread Status:
Not open for further replies.
  1. ec90t

    ec90t Guest

    Hey Jack,

    Tie a piece of fishing line inbetwee a couple of flat washers and just saw through the adheasive. This won't mare the mat finish on the barrel or cut your fingers.

    Use some adheasive remover/WD-40 to move the residue.

    This will also work on the carey-closer if you use a long enough piece of line.

    ec90t
     
  2. ccridr

    ccridr Member

    Joined:
    Jan 29, 1998
    Messages:
    276
    Jack
    The fishing line method works, I use it to remove unwanted name badges from motorcycle tanks. WD 40 will loosen and desolve the remainder of the glue on the rib.
    Colby
     
  3. jmas

    jmas TS Member

    Joined:
    Jan 29, 1998
    Messages:
    114
    If you wind up with some cleanup work to be done, use "Goof Off". Great for removing most mistakes. It will even take off permanent marker ink, gum, glue, crayons, paint, etc.


    No, it won't work on that kind of moral mistake.

    jmas
     
  4. jackmitch

    jackmitch TS Member

    Joined:
    Jan 29, 1998
    Messages:
    815
    mia you should have stuck with the ncp391 with beautiful wood. thats decent looking wood but it ain't ncp wood.jackmitch
     
Thread Status:
Not open for further replies.