1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

mec reloader question

Discussion in 'Shooting Related Threads' started by clayshtr, Jan 2, 2010.

Thread Status:
Not open for further replies.
  1. clayshtr

    clayshtr Member

    Joined:
    Jan 29, 1998
    Messages:
    100
    Location:
    illinois
    I have a mec 9000g reloader with the metal powder baffle installed. I am using the 1 1/8 ounce charge bar that came with it. Should I have the baffle installed with the bronze washer and a rubber grommet. I only have a rubber grommet under mine and am getting a lot of powder showing up on the table. Thanks for any help.
     
  2. tom90T

    tom90T Member

    Joined:
    Jan 29, 1998
    Messages:
    98
    If you want to use the metal baffle you need to also use the bronze washer. If you change to the PC plastic powder baffle that is spring loaded then you will not need any washers. I like the plastic one myself.
     
  3. F-Grade

    F-Grade TS Member

    Joined:
    Dec 31, 2009
    Messages:
    2
    Install the brass washer with the dimples faceing up, on the powder side of the measure assembly,place the neopprene grommet over the washer. This should solve your problem.
     
Thread Status:
Not open for further replies.