1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

MEC question

Discussion in 'Shooting Related Threads' started by jim brown, Feb 9, 2011.

Thread Status:
Not open for further replies.
  1. jim brown

    jim brown Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    1,158
    Location:
    Nebraska
    I have a MEC 9000 with an original Automate. When it cycles it doesn't stop completely at the end of the cycle. It continues with the unit coming down a short distance against the spring then rebounds back to the top. It seems the Automate wheel is acting somewhat like a flywheel and not stopping at the completion of the cycle. No power just flywheel effect. Anybody seen this or have a fix?

    jim brown
     
  2. jim brown

    jim brown Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    1,158
    Location:
    Nebraska
  3. jim brown

    jim brown Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    1,158
    Location:
    Nebraska
    Never mind, I found it.

    Jim brown
     
  4. SCL

    SCL Member

    Joined:
    Aug 2, 2009
    Messages:
    126
    So, what was it?
     
  5. jim brown

    jim brown Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    1,158
    Location:
    Nebraska
    Adjusted the bolt at the bottom of the gas strut. Don't know why but when that was properly adjusted the problem went away.

    jim brown
     
Thread Status:
Not open for further replies.