1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

MEC 9000G TIMING QUESTION

Discussion in 'Uncategorized Threads' started by kuelblaz, Aug 31, 2008.

Thread Status:
Not open for further replies.
  1. kuelblaz

    kuelblaz TS Member

    Joined:
    Aug 14, 2008
    Messages:
    22
    Just finished rebuliding my 9000 and I cnat figure out why the carrier is starting to turn before the handle is up?? (The wad guide rod is not contacting the lower cam bracket early). Its trying to move the shell before its fully lifted
    Any advice?
    Bill Forbes
     
  2. ricks1

    ricks1 TS Member

    Joined:
    May 7, 2007
    Messages:
    1,545
    check the bolt/nut on the bottom of cylinder it is out of ajustment rick
     
  3. kuelblaz

    kuelblaz TS Member

    Joined:
    Aug 14, 2008
    Messages:
    22
  4. kuelblaz

    kuelblaz TS Member

    Joined:
    Aug 14, 2008
    Messages:
    22
    Thanks for the tip. Figured it out, my shell catcher (cardoard box) was pushed up against the linkage. Works fine now.
    Still doing the crimp adjustments, but all is working well

    Thanks again,
    K.
     
Thread Status:
Not open for further replies.