1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

MEC 650 Problem

Discussion in 'Uncategorized Threads' started by ke4yyd, Jun 20, 2008.

Thread Status:
Not open for further replies.
  1. ke4yyd

    ke4yyd Member

    Joined:
    Jul 15, 2006
    Messages:
    323
    This is fairly common when using nontapered primers such as Nobel Sport in once fired cases. Try lowering the die a small amount.
     
  2. maclellan1911

    maclellan1911 TS Member

    Joined:
    Dec 9, 2006
    Messages:
    4,226
    If it does it all the time lower the powder drop/primer seat tube slightly. If it happens here and there I find myself short pulling the handle down, especially if you get going at a good pace. I donr remember word for word but I called mec a while back. with the tube loose place a business card on the primer seat. Then lower handle all the way. With the tube seated against the card. tighten tube. I may be wrong so please call MEC they have walked me through every problem I did not figure out. They also make it seem easy!
     
Thread Status:
Not open for further replies.