I switch my mono gun trigger hammers (pull to release) once in awhile and as anyone that has done it knows, it can be a pain! I saw a thread on here way back where someone made a wrench to help in the process. I would like to make or buy one. Thanks in advance for any information.
Brownells also makes a tool for this purpose...like a heavy-duty blade screwdriver with a "U" cot out in the middle of the blade...makes spring removal a 5 second issue.
Get a screwdriver with the same diameter shaft as the pins in the trigger-Phillips- Grasp the hammer with spring etc and squeeze and use screwdriver as the pin- once the screwdriver is in the hole- drive pin in from the other side replacing the screwdriver.
Pretty easy and fast once you get the hang of it- The tool talked about above also works.
Terry Jones
shooterone! thanks for the infro. I found it and ordered. However the one I was looking for was made more like a c-clamp (I believe it may have been homemade.
This is the type of tool you need for removing mainsprings.
Status
Not open for further replies.
You have insufficient privileges to reply here.
Related Threads
?
?
?
?
?
Trapshooters Forum
4.1M posts
85.3K members
Since 2005
A forum community dedicated to Trap shooting enthusiasts. Come join the discussion about targets, clays, hunting, gunsmithing, gear reviews, accessories, classifieds, and more!