1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Ljutic ejector

Discussion in 'Uncategorized Threads' started by kgp, Mar 13, 2007.

Thread Status:
Not open for further replies.
  1. kgp

    kgp TS Member

    Joined:
    Jan 29, 1998
    Messages:
    68
    I've owned Ljutics in the past, and they had the ejector disabled so the shells just lifted up for easy extraction. I just got another that has the ejector spring in place and I'd like to change it. How do I do it and is it difficult?

    Ken
     
  2. motordoctor

    motordoctor Shoji Tabuchi in Branson

    Joined:
    Jan 29, 1998
    Messages:
    3,622
    Location:
    ohio
    remove the barrel. there is a pin at the back of the chamber near the locking lug. take a drift pin and knock it out from the right side to the left as you would look down the barrel. just tap it and it will come out. the ejector will come out with the spring but make sure to hold it so it does not go flying and the little slide on the front of the ejector pin will have to be removed. be careful not to loose the small spring and the follower. OR if it a later gun there are two small set screws that can be locked in place to hold the piece in the up position on the front of the ejector rod. hope the explaination is easy to follow. motordoc
     
  3. solechicken

    solechicken TS Member

    Joined:
    Jan 29, 1998
    Messages:
    14
    Motordoctor,
    How much spring need to be removed?
     
  4. motordoctor

    motordoctor Shoji Tabuchi in Branson

    Joined:
    Jan 29, 1998
    Messages:
    3,622
    Location:
    ohio
    you have to put the big spring back in so the extractor will work.
     
  5. solechicken

    solechicken TS Member

    Joined:
    Jan 29, 1998
    Messages:
    14
    Got it. Thanks
     
Thread Status:
Not open for further replies.