1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

K-32 Stock

Discussion in 'Gunsmithing' started by ILClaysshooter01, Dec 31, 2016.

  1. ILClaysshooter01

    ILClaysshooter01 Member

    Joined:
    Oct 29, 2012
    Messages:
    224
    Location:
    Northern IL
    Can someone help with the correct size hex wrench to take off the stock on my K-32.

    Thanks.
     
  2. Rebel Sympathy

    Rebel Sympathy Well-Known Member

    Joined:
    Jun 6, 2010
    Messages:
    1,747
    Location:
    Pea Patch, Alabama
    A Model 32 does not take a wrench. It takes a long, fairly large flat-blade screwdriver. Be careful; it is very easy to get the screwdriver wedged between the screw head and the wood, thinking you are in the slot. Then, when you twist the screwdriver you will break out the side of your stock and ruin it. The cure it to get a 4" to 6" piece of electrical conduit - I think it is 5/8" inside diameter you will want. Drop that down in the hole, then drop the screwdriver down. That way you won't be prying against the outsided of your wood if you miss the slot.
    If someone has replaced your original M32 stock bolt with a K80 bolt, then it is 5mm T-handle hex.
     
    EuroJoe thanked this.
  3. ILClaysshooter01

    ILClaysshooter01 Member

    Joined:
    Oct 29, 2012
    Messages:
    224
    Location:
    Northern IL
    Thanks, I was able to shine a light down the bolt hole and it looks like a hex head bolt. The stock was replaced with a custom stock.
     
  4. bobski

    bobski Well-Known Member

    Joined:
    Oct 24, 2011
    Messages:
    2,451
    Location:
    Vanzant Mo., Va Beach Va., Seymour Ct.
    we knew that! :>
     
  5. Tron

    Tron Supporting Vendor Supporting Vendor

    Joined:
    Jan 29, 1998
    Messages:
    6,922
    Try 5mm.
     
    stockmaker12 thanked this.
  6. Taxidermy

    Taxidermy Active Member

    Joined:
    Aug 17, 2006
    Messages:
    971
    More like 5mm, not 6mm. that what a k80 factory stock bolt is a 5mm.
     
  7. ILClaysshooter01

    ILClaysshooter01 Member

    Joined:
    Oct 29, 2012
    Messages:
    224
    Location:
    Northern IL
    Ok thanks for the info.