1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

** Is there a way to soften a recoil pad? **

Discussion in 'Shooting Related Threads' started by ismah, Aug 7, 2011.

Thread Status:
Not open for further replies.
  1. ismah

    ismah Member

    Joined:
    Feb 19, 2008
    Messages:
    518
    Has anybody found a way to do this?
     
  2. Pull & Mark

    Pull & Mark Well-Known Member

    Joined:
    Mar 9, 2006
    Messages:
    5,415
    Yes, Replace it with a Kick-ezz!!! If you already have a Kick-ezz and its mostly wore out replace it with a new Kick-ezz pad. Place the factory pad in the gun safe and leave it there until you sell the gun, then and only then reinstall it on the gun. Break-em all Jeff
     
  3. skeeljc

    skeeljc Supporting Vendor Supporting Vendor

    Joined:
    Aug 27, 2007
    Messages:
    3,747
    Location:
    Terre Haute Indiana
    Put a Gracoil behind it.

    Jim Skeel
     
  4. trapster100

    trapster100 Member

    Joined:
    Jan 29, 1998
    Messages:
    153
  5. Dickgshot

    Dickgshot Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    3,675
    Here's a technique I used on a Beretta pad that was harder than I like.
    I drilled a couple hundred small holes in the pad with a 1/16" drill bit, so there would be less rubber that would have to be compressed. It only took
    about an hour to do that and didn't affect the appearance too much.

    It didn't work, and I replaced it with a Kickeez..
     
  6. sptnclays

    sptnclays Member

    Joined:
    Jan 29, 1998
    Messages:
    574
    Location:
    Grosse pointe farms Mi
    Trap dude gooey
     
Thread Status:
Not open for further replies.