1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

How I fixed my Mec Hydaulic Black Cylinder

Discussion in 'Shoot Information, EVENTS, Clinics & Results' started by jrfloyd, Aug 22, 2012.

Thread Status:
Not open for further replies.
  1. jrfloyd

    jrfloyd Member

    Joined:
    Feb 29, 2012
    Messages:
    20
    Location:
    Cleveland,TN.
    I repaired my Mec 650 hydraulic (black) cylinder for under 5.00. I went to Lowe's and at the hardware department I picked out two gromments. One was an 1 1/8 grommet with a center hole of apprx. 7/16 in Dia....then chose a second grommet that fit the center hole of this grommet with its center hole dia of 1/4"...I inserted the small grommet into the hole of the large grommet creating a grommet in a grommet (outer/inner seal created). I shoved this configuration down onto the threaded end of the shaft, down onto the brass washer...put it all back together and its working great, even now. I tried-due to the fact the cylinder repair kits were hard to find...all I know is it works...FYI
     
  2. Duck

    Duck Member

    Joined:
    Jan 29, 1998
    Messages:
    572
    Thnaks Great Tip!.
     
Thread Status:
Not open for further replies.
Search tags for this page

mec 650 hydraulic