1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Help needed Question on Perazzi MT6 barrels

Discussion in 'Shooting Related Threads' started by OLD ONE EYE, May 25, 2011.

Thread Status:
Not open for further replies.
  1. OLD ONE EYE

    OLD ONE EYE Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    3,254
    Location:
    Florida / Idaho
    Was looking at a MT 6 and at the end of the barrels where they are joined it looked like the soldering was separating when I questioned the seller he posted this

    (There are 5 chokes, #10,8,7,6,2. all the chokes are in good condition, but the finish is a little worn. At the muzzle the front spacer blocks between the barrels are adjustible to change the point of impact. This is factory original.)

    also got a e mail saying Hello,
    If you are looking at my picture #13, the barrels have blocks attached to
    adjust the point of impact, there are two screws that are accessed at the
    muzzle, it is manufactured this way. It isn't the best picture.


    I do not think the barrels are adjustable but do not know for sure any help I can have on this will be useful Buddy
    I may owe an someone a appology
     
  2. OldPshtr

    OldPshtr Member

    Joined:
    Jan 29, 1998
    Messages:
    447
    ALWAYS my understanding MT-6 not adjustable
    for POI. Never saw one factory that was.

    Doyal
     
  3. OLD ONE EYE

    OLD ONE EYE Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    3,254
    Location:
    Florida / Idaho
  4. miketmx

    miketmx Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    2,969
    I vaguely remember a thread on this very topic a year or so ago. I thought there was a small number of MT6 guns that had a feature that didn't work properly and the POI would change radically when the barrels got hot. A gunsmith had to make a repair to fix the problem. ??? A phone call to Ray Stafford might clear this up.
     
  5. dead on 4

    dead on 4 Well-Known Member

    Joined:
    Aug 4, 2009
    Messages:
    3,070
    Call Lucio at Perazzi 626/334-1234, He's in Pacific time zone.


    Surfer
     
  6. twcpdc

    twcpdc Member

    Joined:
    Feb 23, 2010
    Messages:
    600
    Location:
    Louisville
    I looked at the pictures and then looked at my MT6 barrels. My barrels have a solid metal piece not separated like the one in picture 13. Hope this helps some. Tom
     
Thread Status:
Not open for further replies.