1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Help Cantebury Voice Release

Discussion in 'Uncategorized Threads' started by Bob Schultz, Dec 14, 2007.

Thread Status:
Not open for further replies.
  1. Bob Schultz

    Bob Schultz Well-Known Member Supporting Vendor

    Jan 29, 1998
    Tuxedo NC
    Hi Bud,

    You will need to check a couple of things to determine the cause of the problem.

    1. Does the red LED blink every time a target is released when you turn the system on? If so the toggle switch may be bad in the trigger cable. If not there is a short in the system (possibly where someone tried to "repair" it).

    Gary Parker ( our technician ) will be happy to walk you through a more complete diagnostic. You can reach him on our toll free line: 800-684-6329
    We are happy to help you so give us a call. Thanks for using Canterbury equipment!

    Merry Christmas,

    Bob Schultz
  2. arrow

    arrow Member

    Jan 29, 1998
    Hi Bud

    Reversing the wires on this cable will make the unit windmill.
    Throw one target after another when the unit is turned on.

    It will not harm the unit. reconnect the wires so pin 1 connects to pin 1
    at both ends and the unit should work.

    Bryan Pierce
  3. maclellan1911

    maclellan1911 TS Member

    Dec 9, 2006
    start where man has been.
Thread Status:
Not open for further replies.
Search tags for this page

voice release wires windmilling