1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Gunsmith needed

Discussion in 'Shooting Related Threads' started by the old guy, Nov 12, 2011.

Thread Status:
Not open for further replies.
  1. the old guy

    the old guy TS Member

    Joined:
    Oct 31, 2009
    Messages:
    95
    I need a gunsmith, preferably in Pa., that can change a release trigger to pull on an Ithaca 4E.
    PA Bobby
     
  2. grunt

    grunt TS Supporters TS Supporters

    Joined:
    Jan 29, 1998
    Messages:
    5,920
    Location:
    Thousand Oaks Ca
  3. gun fitter

    gun fitter TS Member

    Joined:
    Jan 29, 1998
    Messages:
    2,959
    Try Allems
     
  4. TOOLMAKER 251

    TOOLMAKER 251 Active Member

    Joined:
    Jan 29, 1998
    Messages:
    3,398
    Bobby, it's not a big deal to remove your trigger plate from the bottom of the receiver. Remove 2 trigger guard screws and turn the guard to remove it, remove the screw at underside at back of tang, push top lever to the right and remove screw under top lever, remove 3 bottom screws at front of trigger plate and pull plate with trigger attached to it off receiver. The 3 screws on the bottom should be marked so when reinstalling they go back in same holes for timing, all you need are proper bladed screwdriver's or tips. It takes less then 5 minutes to remove that trigger plate.
     
  5. the old guy

    the old guy TS Member

    Joined:
    Oct 31, 2009
    Messages:
    95
    OK Thanks but what will this get me?
     
  6. the old guy

    the old guy TS Member

    Joined:
    Oct 31, 2009
    Messages:
    95
    WOW !!!! That was easy. Thanks.
     
Thread Status:
Not open for further replies.