1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice


Discussion in 'Uncategorized Threads' started by Haskins Bill, Nov 5, 2007.

Thread Status:
Not open for further replies.
  1. Haskins Bill

    Haskins Bill TS Member

    Nov 4, 2007
    Does anyone have any info about the Econoshot maker from Clinton New York? I have an ad from several years ago and have been unable to contact them. It is a single orfice shotmaker that uses a propane torch for a heat source. Actually I would like to know the orfice sizes for various sizes of shot. Do you make them the nominal size of the desired shot or a little bigger or smaller? Has anyone used a Lee Prodution pot with modifications to make shotgun shot? Is dead soft plumbers lead suitable for shot or do you need to alloy it? Thanks Bill Hale
Thread Status:
Not open for further replies.