1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Convert a Ljutic to Only Extract??

Discussion in 'Uncategorized Threads' started by motordoctor, Dec 1, 2007.

Thread Status:
Not open for further replies.
  1. motordoctor

    motordoctor Shoji Tabuchi in Branson

    Joined:
    Jan 29, 1998
    Messages:
    3,680
    Location:
    ohio
    if it a newer gun the flat piece that the pin goes through may be drilled and tapped for two small allen screws. If not take it apart and remove that plate and put it back together. the pin removed from the right to the left. motordoc
     
  2. biff

    biff Active Member

    Joined:
    Jan 29, 1998
    Messages:
    1,140
    Take barrel off. Turn it upside down. There are two small allen screw holes in front of the block which holds the release for the ejector. Loosen those two very small allen screws and push down on the activator, while holding it down even with the block, tighten those two small allen screws so they hold this sliding activator even with that block. It will now extract, however if the screws come loose and release that lock, which sometimes happens just do it again making sure you get them tight. Just don't go taking things apart if you aren't sure what you're doing, OK Biff
     
  3. motordoctor

    motordoctor Shoji Tabuchi in Branson

    Joined:
    Jan 29, 1998
    Messages:
    3,680
    Location:
    ohio
    John Leave it all together. Ljutic will send you the screws. Put the two screws in , push the plate up and lock it down. No ned to take apart. Motordoc
     
Thread Status:
Not open for further replies.