1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Choke Tube Manufacturer

Discussion in 'Shooting Related Threads' started by bigbore613, Apr 11, 2013.

Thread Status:
Not open for further replies.
  1. bigbore613

    bigbore613 Active Member

    Joined:
    Jan 29, 1998
    Messages:
    4,469
    Almost like Rhino but the holes arent chamfered. Jeff
     
  2. stokinpls

    stokinpls Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    6,486
    Look like Clearviews from Larry Nailon in Oklahoma City. If you look real close about half-way up you might still be able to make out the amount of constriction .015 or some other value etched into the choke body. Mine are excellent chokes. Only complaint I had was the slot for the Browning choke tube wrench was too small. Been shooting mine 15+ years. Back when I bought mine, I had to send the barrels to him so that he could mic the bore size (my Citori Plus was 0.742)and then make the chokes. I believe I've read where Larry has since retired. Good luck.

    Bob Falfa
     
  3. Tron

    Tron Supporting Vendor Supporting Vendor

    Joined:
    Jan 29, 1998
    Messages:
    6,665
    Looks like a garage machinist.
     
  4. BigM-Perazzi

    BigM-Perazzi Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    8,542
    Location:
    HELL, MICHIGAN
    If so, I'd hire him!
     
Thread Status:
Not open for further replies.