Trapshooters Forum banner

Bushing id

2K views 7 replies 5 participants last post by  icelander36 
#1 ·
.998 tall with a diam. of .810.
 
#2 ·
Those appear(from looks) to be older Pacific bushings. I have an old Pacific DL300 that uses different bushings than a Pacific/Hornady DL366 uses. I'll measure the bar holes for you if you can give me a little bit.
 
#3 ·
The standard Hornady bushings for a 366 measure:
Measuring instrument Technology Electronic device Auto part Pedometer


Tire Calipers Automotive tire Measuring instrument Technology



The bushings for my DL300 measure:

Measuring instrument Calipers Gauge Auto part Technology


Calipers Measuring instrument Technology Gauge Tool





They fit my Pacific DL300. The measurements are close enough where the variance in measurements are simply errors in my measuring or yours.

Those bushings are older bushings.
 
#8 ·
Brdslayr,

I have one of those bars on one of my Mec 600 Jr reloaders. The lead bushing is 995 tall and 810 dia. The powder bushing is same height and 790 dia. They are marked on the side TEXAN with letter a, b, C, and so on for the powder and 4X, 6, and 8 on the lead bushing. How much are you looking to get for them???

Lyle
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top