1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

*****Browning XT UNSINGLE*****

Discussion in 'Uncategorized Threads' started by likes-to-shoot, Dec 17, 2007.

Thread Status:
Not open for further replies.
  1. likes-to-shoot

    likes-to-shoot Well-Known Member

    Joined:
    Oct 6, 2006
    Messages:
    6,079
    Location:
    Iowa
    Goose.......I use the O/U barrels and a snap cap. Its a pain but its the only way I know to be on the safe side.

    Were you the person who was looking for the instructions on setting the un-single rib a while back? If so I found mine and could e-mail you a copy.

    Bill
     
  2. Flench

    Flench TS Member

    Joined:
    Jan 29, 1998
    Messages:
    38
    Hold a coin over the firing pins and snap them. Use a 25 cent piece.


    DoyalKirby
     
  3. likes-to-shoot

    likes-to-shoot Well-Known Member

    Joined:
    Oct 6, 2006
    Messages:
    6,079
    Location:
    Iowa
    Doyal..... Thats one of them good ideas that everyone says " Why didn't I think of that." LOL Thanks

    Bill
     
  4. Inspector 12

    Inspector 12 TS Member

    Joined:
    Jan 29, 1998
    Messages:
    192
    I have also used a spent shotgun shell for a snap cap when decocking the gun. Just hold the shell over the firing pin hole and pull the trigger. A firm bounce will reset the inertia block so the second barrel can be released as well.
     
Thread Status:
Not open for further replies.