1. We have added the ability for anyone to 'bump' threads that they have created. This is mainly useful in the classifieds area where posters constantly bump for sale threads to bring it to the top. This allows them the ability to do that without having to clutter the thread with extra 'TTT' and 'Bump' type posts. To bump it, go inside your thread and click on 'Thread Tools' at the top, then select 'bump'. You can bump only once per 24 hour period.

    For more detailed information please see this post: Thread Bump Functionality.
    Dismiss Notice
  2. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Browning Xt unsingle rib adjustment directions

Discussion in 'For Sale- Members only' started by dedpair, Dec 11, 2010.

Thread Status:
Not open for further replies.
  1. dedpair

    dedpair Active Member

    Rating - 100%
    1   0   0

    Joined:
    Jan 29, 1998
    Messages:
    490
    I don't have the manual anymore, but adjustment is very simple. I loosened the 2 middle screws, then lowered the back of the rib to the lowest point. I then adjusted the front of he rib till I had the POI I wanted. I left the comb set from when I set POI on the O/U barrels. Once I had that done I then raised the back of the rib to the site picture I wanted and locked the middle screws. I would recommend, using a level to re-balance the rib, otherwise you could possibly end up bending the rib. The simple rule is that the lower you adjust the rib in front, the higher it will shoot, and lower, the higher you adjust. It's really a balancing act between both sets of barrels. But I had no problem getting all 3 barrels to shoot 110% high, but did have a slightly different site picture with both barrels.

    Hope this helps or was the info you needed.

    Jeff Graupp
     
Thread Status:
Not open for further replies.