1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Browning Repair Question

Discussion in 'Uncategorized Threads' started by mirage1, Dec 4, 2007.

Thread Status:
Not open for further replies.
  1. mirage1

    mirage1 Member

    Joined:
    May 16, 2006
    Messages:
    293
    I have a Browning 410 Citori o/u. I would like to remove the extractors
    and give the area a good cleaning, however I don't understand how they are removed.
    It appears simple but when I slide the extractor over and line it up with the
    screw below and then try to remove the screw the screw only backs out so far then stops. The extractor is still not free to slide out because the screw
    needs to be completly removed?
    Thanks,
    Joe
     
  2. Shooting Coach

    Shooting Coach Well-Known Member

    Joined:
    Sep 14, 2006
    Messages:
    8,358
    Location:
    Nashville Tn
    The plug screws must be removed to get the extractors out. Make sure you retighten the screws when you put the gun back together. There will be a lot of goop under the extractors if you have shot the gun much.

    Using aerosol brake cleaner, compressed air and a good gun oil is the key to servicing these fine guns.
     
  3. mirage1

    mirage1 Member

    Joined:
    May 16, 2006
    Messages:
    293
    Thanks for the info coach-I will give it another look.
     
Thread Status:
Not open for further replies.