1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Blueprint for Rem 1100/1187 receiver?

Discussion in 'Shooting Related Threads' started by Brian in Oregon, Jan 13, 2010.

Thread Status:
Not open for further replies.
  1. Brian in Oregon

    Brian in Oregon Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    25,254
    Location:
    Deplorable Bitter Clinger in Liberal La La Land
    I'm looking for a blueprint of the Rem 1100 or 1187 receiver. You'd think after making these for 47 years that someone would have made a set of blueprints or dimensional drawings by now.

    I guess if nothing turns up I'll start looking for a worn out or ruined 1100 to section in my milling machine.
     
  2. kirbythegunsmith

    kirbythegunsmith Member

    Joined:
    Jan 3, 2008
    Messages:
    192
    Is there a reason that you can state for needing a 'print or a "botch" frame to section, and if you just need a chunk, what part is the important part to have?

    Kirby
     
  3. Brian in Oregon

    Brian in Oregon Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    25,254
    Location:
    Deplorable Bitter Clinger in Liberal La La Land
    I'm at the blueprint stage for a gun part, and I need a blueprint for the cross section of an 1100 or 1187, or a bad receiver to section on my milling machine. If a receiver has been cut in two, it's the rear half that I need.
     
Thread Status:
Not open for further replies.