1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Beretta Quality issues?

Discussion in 'Shooting Related Threads' started by rifle guy, Jan 3, 2010.

Thread Status:
Not open for further replies.
  1. rifle guy

    rifle guy TS Member

    Joined:
    Jan 25, 2007
    Messages:
    103
    I was wandering about in the local scheels store, saw a 30" bbl beretta 28ga o/u.and fell in love from afar... then picked it up...The action broke smoothly and the engraving was ok but the butt pad was only half shaped leaving about .100" excess at the toe. The finish on the stock was thin and didn't fully fill the grain. on sale at $2099 i would expect much better.

    Is this a trend or a bad example?
     
  2. W.P.T.

    W.P.T. TS Member

    Joined:
    Jan 29, 1998
    Messages:
    8,371
    Sounds like somebodys junk they tried to dressed up to sell ... WPT ... (YAC) ...
     
  3. rifle guy

    rifle guy TS Member

    Joined:
    Jan 25, 2007
    Messages:
    103
    I believe it was new at least it was in their new rack along with three or four other similar models in 12ga & 20ga.

    They claim to have a "gunsmith" in house. Whom I would assume should have no problem fitting a pad properly... I sure hope it isnt beretta's fault.
     
  4. Leo

    Leo Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    3,048
    I have never seen what you are describing. There must be more to the story.
     
Thread Status:
Not open for further replies.
Search tags for this page

beretta quality problems