1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

AA Lite Powder

Discussion in 'Uncategorized Threads' started by kjsncnb, Mar 18, 2008.

Thread Status:
Not open for further replies.
  1. kjsncnb

    kjsncnb Member

    Apr 26, 2006
    I am going to try some loads with the new Winchester AA Lite powder, has any one used it that can tell me a good starting point for bushings in a PW or 366.

    The load calls for 14.6 grains

  2. Capt. Morgan

    Capt. Morgan TS Member

    Aug 27, 2007
    I experiment when I can't find data to start from...

    I place a bushing in the corner of a small (3X3) piece of 1/4" Lexan that sits on the bench. I trickle powder into the bushing until it's full and then strike off the top so the powder is flush with the bushing. Pick up the plastic and hold the corner over the powder pan for your scale. Slide the bushing off the edge to dump the powder into the pan so you can weigh it. (You DO use a scale, right?) Then stick that bushing in your loader to see what it throws. My powder drops are within 1 or 2 tenths between the plastic and the loader.

  3. deking00

    deking00 Member

    Jan 29, 1998
    I have had good luck emailing for information. Below is from their web site.

    Free Technical Support: help@wwpowder.com or (913) 362-9455
Thread Status:
Not open for further replies.