1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

1100 fork shell catcher

Discussion in 'Shooting Related Threads' started by dgh, Mar 15, 2012.

Thread Status:
Not open for further replies.
  1. dgh

    dgh Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    4,167
    Location:
    League City Texas, USA
    Hello All.

    I just bought this from a fellow TS poster,

    I have never used one on an 1100, I have just seen them from a distance,

    My question is did they make these for 20 gauge as well?

    I have not fired it yet, However the 12 gauge hull does not slide down in the slot. A 20 gauge hull slides in great.

    anyone have one they use and can verify this for me?

    Thanks Doug
     
  2. mrskeet410

    mrskeet410 TS Member

    Joined:
    Jan 29, 1998
    Messages:
    3,064
    They work, they just don't fit well in the later models of the action bar since they changed the location of the bolt detent pin.
     
  3. dgh

    dgh Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    4,167
    Location:
    League City Texas, USA
    Detent is in correct place,

    Just seems the slot is too narrow, I need some one that has one to tell me if the hull slides down it.

    Or measure the width,

    Thanks Doug
     
  4. mrskeet410

    mrskeet410 TS Member

    Joined:
    Jan 29, 1998
    Messages:
    3,064
    The hull doesn't slide down it. It just get stuck in the front end.
     
  5. lostandout

    lostandout Member

    Joined:
    Jun 29, 2010
    Messages:
    450
    a used shell will only go about half wat its .800at the front and.700 at the back hope this helps

    brian
     
Thread Status:
Not open for further replies.