Trapshooters Forum banner
Status
Not open for further replies.

loading bench

7K views 39 replies 31 participants last post by  Beretta Young Gun 
#1 ·
just trying to insert a picture with my limited computer skills.

 
See less See more
1
#6 ·
Show off! Just kiding, it is cool.


I'm just now building mine and will start with a mere MEC Jr. At 6'4", I built mine much taller 40" where I could either stand comfortably, or sit my buttocks on the adjustable bar stool I bought.


Nice job with picture and bench.


Guy Babin
 
#8 ·
shot410ga, I'm only 4'22" and way too lazy to stand up and load shells. The bench is 32" high and I sit on a stool made to match the bench. It's visible on the left side of the picture. As for the best loader it's the Spolar no doubt about it. See the Spolar opinion thread.
 
#10 ·
John, No sorry I have no more of the Nitro 100. Someone gave me that cardboard container. I have an elbow of plastic electrical conduit under the bench that the loaded shells from the P.W.loader eject into the old powder container. They come out the side where the cardboard container is setting.
 
#21 ·
Yes the wad and hull dispensers are P-W . I bought them off this site along time back .

On the other wall is a gun safe and cabnets for reloading stuff .

My wife had a fit about my loading stuff in the house and for years I put up with the crap . About six years ago I built a 28X32 out building just for my stuff . It has heat and cooling plus all the stuff you ever would need .
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top